Liebherr ECBN 5066 PremiumPlus BioFresh NoFrost - Manual (Page 6)

Power failure/FrostControl display
If the LED comes on on the control panel, this means that the
freezer temperature has risen too high during the last few hours
or days due to a power failure.
If you touch the ALARM icon now, the highest temperature
registered during the power failure will be displayed.
Check the quality of the food and its suitability for consump-
tion in case it has become too warm or even defrosted.
The highest temperature will appear for appox. 1 minute. After
that, the actual temperature in the freezer will re-appear.
The display can be switched off by touching the ALARM icon.
Audible warning signal
The appliance is equipped with an alarm function.
Audible door alarm
If an appliance door is left open for more than 60 seconds,
the audible warning signal will sound. Touch the ALARM
icon to cancel the alarm. The alarm switches back to
standby when the door is shut.
Audible/visual temperature alarm
It sounds when it is not cold enough in the freezer compartment.
The temperature display and the LED will also flash.
The audible warning device is switched off by touching
the ALARM icon. The temperature display will continue
to flash until the cause of the alarm has been rectified.
This can be caused by:
• the freezer door being left open for a long time, allowing warm
ambient air to enter;
• a long power failure;
• a fault in the appliance.
In each case, make sure food has not thawed or perished.
SuperCool
Touching the SuperCool icon switches the refrigerator compart-
ment to maximum cooling. It is recommended particularly if you
wish to cool large quantities of food, drinks, freshly baked goods
or meals rapidly.
Switching on: Touch the SuperCool icon briefly so that
the LED comes on. The refrigerator temperature will
drop to its lowest value.
Note: The SuperCool function uses slightly more energy. After
approximately six hours, however, the refrigerator switches back
automatically to normal energy-saving operation. If required, the
SuperCool function can be switched off sooner.
Switching off: Touch the SuperCool icon again until the LED
goes out.
Setup mode
The following functions can be activated in setup mode:
= Sabbath mode
= Child lock
= Confirm water filter change
= Ice maker vacation state
= Water quantity for ice cube tray
= Set BioFresh temperature
= Display brightness
= Door gasket heating control
=Confirm dust filter cleaning
Activating setup mode
• Touch the SuperFrost icon for five seconds.
- The SuperFrost LED comes on for 5 seconds,
- after 5 seconds will flash in the display.
The appliance is in setup mode now.
You can select the setup mode functions by touching
the freezer compartment temperature setting icons.
Note
In setup mode the display will flash continuously.
Exiting setup mode
• Touch the freezer compartment On/Off icon
The appliance will change back to normal operation.
20