Liebherr ECBN 5066 PremiumPlus BioFresh NoFrost - Manual (Page 8)

= Lower hinge heating control
If condensed water appears in the lower
hinge area or on the base plate between
refrigerator and freezer compartment,
increase the output of the heating lo-
cated behind the base plate.
The factory setting is set to = me-
dium output.
Changing the heating output
• Activate setup mode by touching the
SuperFrost icon for 5 seconds.
• Touch the freezer compartment Down
icon until appears in the display.
• Touch the SuperFrost icon.
- The display reads
• Touch the freezer compartment
Up/Down icons to select
= at slight condensation
= at heavy condensation
= heating off
• Touch the SuperFrost icon at the desired value.
• Exit setup mode by touching the freezer compartment On/Off
icon.
Note
With normal ambient conditions no condensation will appear. With
high humidity and low ambient temperature this feature helps to
prevent condensation.
= Display brightness
Adjusting the display brightness
• Activate setup mode by touching the SuperFrost icon for
5 seconds.
• Touch the freezer compartment Down icon until appears in
the display.
• Touch the SuperFrost icon.
- The display reads
• Touch the freezer compartment
Up/Down icons to select
0 = minimum to
5
= maximum brightness.
• Touch the SuperFrost icon at the desired value.
• Exit setup mode by touching the freezer compartment On/Off
icon.
= Ice maker vacation state
See section entitled "Ice maker".
= Water quantity for ice cube tray
If the produced ice cubes of the ice maker are too small, the
inflowing water quantity can be adjusted.
Adjusting the water quantity
• Activate setup mode by touching the SuperFrost icon for
5 seconds.
• Touch the freezer compartment Down icon until appears in
the display.
• Touch the SuperFrost icon.
- The display reads
• Touch the freezer compartment Up icon once only so that E 4
appears in the display.
Caution!
Do not increase for more than one step. If the adjusted value
is too high, the ice cube tray of the ice maker could overflow.
• Touch the SuperFrost icon again.
• Exit setup mode by touching the freezer compartment On/Off
icon.
Check the ice cube size within the next days. If the ice cubes are
still too small, follow the steps above again.
= Set BioFresh temperature
The temperature in the BioFresh drawers may be changed.
Setting the BioFresh temperature
• Activate setup mode by touching the SuperFrost icon for
5 seconds.
• Touch the freezer compartment Down icon until appears in
the display.
• Touch the SuperFrost icon.
- The display reads
• Touch the freezer compartment Up/Down icons
and set
6 - 9 to increase the temperature (warmer),
4 - 1
to reduce the temperature.
CAUTION!
For values b4 - b1, the temperature in the drawers can
drop to below 0°C. Food may freeze.
• Touch the SuperFrost icon at the desired value.
• Exit setup mode by touching the freezer compartment On/Off
icon.
22