New Buck Corporation 18 - Manual (Page 13)

SECTION III
PRE-FAB
ZERO CLEARANCE INSERT INSTALLATION
The Model 18 may be installed into any UL listed prefabricated fireplace that is large enough to
accept it.
MINIMUM CLEARANCES
Except for “NOTE(S)”, FOLLOW MASONRY INSTALLATION CLEARANCES FOUND
IN YOUR OPERATIONS MANUAL.
INSTALLATION PREPARATION
Pre-Fab Zero Clearance Fireplace
1. Locate furniture and other materials away from the front of the fireplace to allow free access
to the fireplace.
2. Cover the hearth and adjacent floor areas with drop cloths to protect from soiling or marring
the surface.
3. Remove the existing fireplace damper plate/damper rod assembly.
4. Thoroughly clean the fireplace of ashes and soot.
5. Check the chimney and smoke chamber for excessive buildup of creosote or soot. Also,
check for obstructions, such as bird’s nests. If the chimney is excessively dirty, clean it, or
have someone clean it professionally BEFORE installing or using the room heater.
6. The Ash Lip, Smoke Baffle and Smoke Shelf may also be removed, if necessary, to provide
room for the Model 18. Any other alteration to the unit will void ALL NBC manufacturer’s
responsibility and liability. The WARNING label below must be attached to the back of
the fireplace.
NOTE: Plug the power cord into a 115 VAC outlet. Route the cord to prevent damage to the
cord insulation from heat and sharp objects. Keep the cord out of the way of traffic to prevent
damage caused by tripping, etc.
WARNING:
This fireplace must be
restored to its original condition for safe use,
if the fireplace insert is removed.
11