New Buck Corporation 18 - Manual (Page 29)

INSTALLATION OF CLOSE
CLEARANCE SHIELDS (Optional)
Take rear close clearance shield and align it with the pre-punched holes in the rear skin of
stove. Insert self-tapping screws through the shields into the stove.
Next, take side shield (end with the holes goes toward the rear of the stove) and insert the
screws through the holes in the side shield into the rear shield. Before tightening the screws
insert the front end of the shield behind the side angle on the front side of the stove. Use the
same step to install the other side shield on the opposite side of the stove.
Next loosen two top screws holding side shield at rear top. Insert pipe shield where back
shield and top rear side shield meets. Tighten screws.
27