New Buck Corporation 18 - Manual (Page 17)

SECTION IV
RESIDENTIAL FREESTANDING INSTALLATION
MINIMUM CLEARANCE TO COMBUSTIBLE MATERIAL
PREPARING THE STOVE FOR INSTALLATION
1. Remove the protective plastic wrapping from the unit.
2. Inspect the unit for any obvious physical damage.
NOTE: Plug the power cord into a 115 VAC outlet. Route the cord to prevent damage to the
cord insulation, from heat and sharp objects. Keep the cord out of the way of traffic to prevent
damage caused by tripping, etc.
3. Check the primary air draft control to ensure that it slides freely.
4. Remove any items from within the firebox. Spread the dropcloth on the floor behind the
heater. Next, tilt the heater so that the back is on the drop cloth.
5. If leg kit is to be used follow steps 1-4. Then obtain legs, bolts, washer & nuts. Attach the
legs to holes in bottom of unit. Reposition the heater to the upright position.
6. If pedestal kit is being used follow steps 1-4. Open the corresponding freestanding kit and
obtain the stand. Place the stand against the bottom of the heater (angle side to heater) at
the marked line. Center the stand left and right and mark screw locations on
bottom through outer holes of stand mounting angles. Set stand aside and drill four 7/32"
holes in heater bottom. (See Figure 5.)
Figure 5
7. Obtain four 1/4" self-tapping screws and secure the stand to the heater.
8. Reposition the heater to the upright position.
15