Philips 4 HD SMALL CLOCK VCR - Manual (Page 42)

42 Time Search
Time Search
Follow the steps below to program the VCR to search forward or
backward a specific length of time.
2
Press the TIME SEARCH button to bring up the time search
display. There must be a tape in the VCR.
3
Within 10 seconds, use the Number buttons to enter the
desired length of time you want to skip forward or back-
ward. For example, for 1 hour, 25 minutes, press Number but-
tons 1, 2, 5. Or, for five minutes, press Number buttons 0, 0, 5.
(Make an entry within 10 seconds of pressing the TIME SEARCH
button. Otherwise, the VCR will exit Time Search mode.)
4
Within 10 seconds, press the F.FWD button or the
REW(ind) button to skip forward or backward. The VCR
will skip over the specified length of time, then begin playback.
(The time counts down on-screen as the searching progresses.)
• If you want to search for more than
59 minutes, you must enter the
length of time in hours and minutes.
For example, to search forward 70
minutes, press 1,1,0 at step 3.
• You can not enter the TIME
SEARCH menu when you are in
Recording mode.
• You can remove the Time Search
display by pressing the TIME
SEARCH button again.
• To cancel the Time Search when the
VCR is fast forwarding or rewinding,
press the STOP button once or the
TIME SEARCH button twice.
Helpful Hints
TIME SEARCH
0:00
ENTER SEARCH TIME
REW
PLAY
POWER
VCR PLUS+
/ENTER
SPEED
VCR
TIME SEARCH
TV
MUTE
CABLE
/DSS
VCR/TV
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY SLOW PAUSE/STILL
MENU CLEAR EJECT
STOP
F.FWD – +
1 2 3
4 5 6
7 8 9
0 +100
2
3
4
1
Press the VCR button.
1