Philips SGC2910-27 - Manual (Page 27)

4 . You will see the screen below . Click on Allow .
5. Once initialization has finished, the SGC2910 Wireless PC Controller’ Install Wizard screen will appear.
6 . After reading the notice, press the ‘NEXT’ button to begin the software installation . You should now see
the screen indicating that the software is being installed on your system .
7 . Note: During installation of Windows Vista the following Windows security message will appear:
“Windows can’t verify the publisher of this driver software” . Please click “Install this driver software
anyway” .
8 . In Windows Vista the SGC2910 Wireless PC Controller should be connected to your Computer before
beginning software installation . If the SGC2910 is not connected to your PC, the following message will
appear “Please Plug into the Wireless PC Controller” . If this message appears, plug the controller in to your
computer . You may need to wait a few seconds for Windows to load the HID drivers . Once completed,
you can click the “OK” button .
EN
Vista 32 Addendum
27
EN