Philips Internet-DECT phone VOIP8411B - Manual (Page 33)

31 Settings
8.6 Extra features
Discover and explore the additional features your
phone offers! Find out how these features can
benefit you and help you make the most from
your phone.
8.6.1 Keypad lock
You can lock the keypad to prevent accidental
presses on the handset while you are carrying it
around.
Lock the keypad
In idle mode:
Press and hold .
• The keypad is locked, and is displayed.
Unlock the keypad
In idle mode:
Press .
• Press * to unlock? is displayed.
Press
to unlock.
• The keypad is unlocked.
8.6.2 Search missing handset(s)
In idle mode:
Press on the base unit.
• All the handsets connected to this base unit
ring.
Press on the base unit again to stop
paging.
• All the handsets stop ringing.
OR
Press any key on the handset to stop the
paging of that handset.
8.7 System settings
8.7.1 Set your country code
The country setting of your phone has been set
during the initial set up of your phone. You can
make changes to the country code on your
phone. The country code is the international
calling code for a country (example, “1” for
Canada), see“Country codes list”, page 35.
Please refer to glossary for details about country
code, see page 40.
In idle mode:
Press .
Scroll to Settings. Press
.
Scroll to Call Settings. Press .
Scroll to Country Code. Press .
Edit the country code. Use to make
corrections.
Press .
• The new setting is saved.
Warning
The phone may not work properly without
correct country code entry.
Note
After country set up, your handset's power
switches off. It will switch back on in a few
seconds after updating the country settings.
8.7.2 Register your handset(s) with
additional base
This section shows you how to register your
handset to additional base unit(s). If your handset
displays Unregistered, refer to “Register the
handset”, page 12.
In idle mode:
Press .
Scroll to Settings. Press
.
Scroll to Handset. Press .
Scroll to Register. Press .
Enter the system PIN (Default: 0000). Use
to make corrections.
Press to confirm.
• Your handset starts searching for the base.
Press
on the base unit until the two
indicators start blinking.
Note
Each handset can register up to 4 base units. After
registering to 4 base units, your handset
registration memory is full.
8.7.3 Select a base unit
You can switch your handset between different
base units if your handset has registered to these
base units. For your convenience, you can
1 Unlock
2
1
2
2
1 Menu
2 Select
3 Select
4 OK
5 Clear
6 OK
!
1 Menu
2 Select
3 Select
4 Select
5
Clear
6 Enter
7