Behringer 32-Channel - Manual (Page 11)

11 X32 DIGITAL MIXER Preliminary User Manual
Inputs
-6
-12
-18
-24
-30
-36
-42
-48
-54
clip
Link
Gain
dB 00.00
Send Pos. Insert Pos. Insert
Link Bus Sends Insert Connect
Pre
LeOnde.mp3
29 November 2010 Scene01
13:44:43 MyProj.prj
00.05.00 00.00.00
home gate dyn eq sends main config
Bus Configuration Bus Insert Position
Insert
Ins 02
FX 01
FX 02
Ins 01
...
Ins 03
Ins 04
All Channel Sends
Pre Configuration
Inputs
Sub Grou
...
Post Fader
Pre EQ
Pre Fader
Insert Post Pre
∑ Channel Sends
The configuration of Mix Bus Channels 1-16 can be pre-set (in the Setup/Global
page) or can also be configured on an individual, per-channel basis. The bus
processing includes (in this order):
• Insert point (swappable between post-EQ and pre-EQ operation)
• 6-band fully parametric EQ
• Compressor/expander (swappable between post-EQ and pre-EQ operation)
• Bus sends to 6 matrices (post-fader)
• Main LR panning
• Mono/Center level
Main Bus Channels LR/C are always available and independent from Mix Buses.
The processing steps for this signal path include (in this order):
• Insert point (swappable between post-EQ and pre-EQ operation)
• 6-band fully parametric EQ
• Compressor/expander (swappable between post-EQ and pre-EQ operation)
• Bus sends to 6 matrices (post-fader)
Matrix Channels 1-6 are fed exclusively by MAIN LRC and Mix Bus 1-16 signals.
The processing steps include (in this order):
• Insert point (swappable between post-EQ and pre-EQ operation)
• 6-band fully parametric EQ
• Compressor/expander (swappable between post-EQ and pre-EQ operation)
Effects Processing 1-8
The X32 console contains eight true-stereo internal effects engines.
• FX 1-4 can be configured as side chain or insert effects, while FX 5-8 can only
be used in insert points of channels or buses
• The returns of side chain FX 1-4 can always be controlled using the 3rd bank
(layer) of the input channels - Aux/USB/FX Returns. Note that the return
signals of FX 1-4 have separate faders for left and right
• The FX Home screen allows selection of the FX 1-4 input sources and
selecting the effects type/algorithm for each of the 8 FX slots of the
virtual rack
• The subsequent tabs FX 1-FX 8 of the FX screen allow editing all parameters
of the chosen effects processor