Behringer 32-Channel - Manual (Page 33)

33 X32 DIGITAL MIXER Preliminary User Manual
6. XUF FireWire400/
USB Interface Operation Guide
Host system requirements for XUF FireWire/USB
interface expansion card
Check the BEHRINGER website at behringer.com for updates of XUF firmware
or system requirements. Please find the recommended hardware/software
minimum configurations in the specifications section.
The BEHRINGER XUF High-Performance 32-Channel
24-Bit FireWire/USB Audio Interface
The XUF card provides 32 channel, bi-directional audio I/O via FireWire 400 and
USB 2.0 to Mac or Windows PC. The simultaneous 32-in, 32-out audio channels
enable extremely powerful studio and live applications. You can run virtual live
sound checks or 32-track high-quality studio recordings, while at the same time
remote operating your DAW via HUI/MackieControl emulation. The high speed
24-bit signal transmission and ultra-low latency ASIO drivers and CoreAudio
compatibility even allow inserting audio plugins on your PC to perform advanced
outboard processing.
6.1 Configuring the XUF card for use in
the console
The console will automatically detect the XUF card during the regular boot cycle,
and it will display the card’s presence in several instances.
The green square in front of “C: XUF” indicates that the card is installed and
working properly.
FireWire/USB
After the console has fully booted up, you can access the Setup/Card screen to
view the current channel count configuration. Use this screen to determine
whether the FireWire or the USB interface is to be used, and if the maximum
channel count is set appropriately.