Bissell PROHEAT 25A3 - Manual (Page 11)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
11
O
perations
Empty the 2-in-1 water tank/
clean removable nozzle
1. Turn power switch off. Remove the 2-in-1 water
tank from the base using the tank carry handle.
Carry the tank like a bucket to a utility sink or
outside where you will dispose of the collection
water. Remove the top of the tank by rotating the
handle forward to unlatch lid and lifting lid
off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint screen
located on the tank lid.
4. If nozzle needs to be cleaned: remove by grasp-
ing handle at the top and pulling forward. Clean
removable nozzle by rinsing under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on the
base with the hooks on nozzle. Attach at base
first and then click nozzle into place.
NOTE: If nozzle is not attached properly
loss of suction will occur.
6. To continue carpet cleaning, refer back to pages
9 and 10, beginning with “Fill the 2-in-1 water
tank” on page 9.
If cleaning is complete, refer to the
“Maintenance and care” section on
page 15.
2.
3.
1.
5.
Lint Screen
4.