Bissell PROHEAT 25A3 - Manual (Page 9)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
9
O
perations
Before you clean
1. Move furniture to another area if
cleaning an entire room (optional).
2. Vacuum area with a dry vacuum cleaner
before deep cleaning.
3. Plan your cleaning route to leave an exit
path. It is best to begin cleaning in the
corner farthest from your exit.
4. Pretreating (optional)
Pretreating is recommended to improve
cleaning effectiveness for heavily soiled
carpet in high traffic areas such as entry
ways and hallways.To pretreat:
A. Using the BISSELL Tough Stain
Pre-cleaner, generously spray evenly
over soiled area, do not overwet.
B. Wait 3-5 minutes before deep cleaning.
C. Clean as normal using your
BISSELL PROheat ® .
Fill the 2-In-1 water tank
1. Remove the tank from the base of the
machine by lifting the tank carry handle.
2. Carry like a bucket to the sink. Rotate the
handle forward to unlatch the lid. Remove
lid, turn over and locate built in measuring
cup.
3. Fill with BISSELL 2X formula to the indi-
cated fill line on the built in measuring
cup and pour into mouth of the bladder.
4. Fill the bladder with clean hot tap water.
*Do not boil or microwave water as it
can destroy the bladder.
5. Replace the top of the tank by matching
the lid and tank edges. Handle must
be in the forward position in order to
replace lid. Rotate the handle to the car-
rying position to latch the lid.
Note: Remember to secure the lid
and test to make sure it is secure
before picking up the tank.
6. Place tank into machine base, seating
firmly in place. Rotate tank handle back
into latched position.
ATTENTION:
Some Berber carpets have a tendency
to fuzz with wear. Repeated strokes
in the same area with an ordinary
vacuum or deep cleaner may
aggravate this condition.
2
4'
3'
1
3
4
5
6
7
9
10
11 12
EXIT
START
HERE
5.
4. 3.
6.
1.
2.