West Bend Back to Basics UX-CC500 - Manual (Page 63)

Transfer Function
61
3. Ans
w
er
ing
Machi
n
e
Turning the Transfer function on and off
When you go out and wish to use the Transfer function, turn it on as follows:
1
Press once and once.
2
Press once and 4 times.
3
Press .
4
Press to turn on the Transfer
function.
(Press to turn the function off.)
5
Press the number of the box for which you want the Transfer function to
operate (for the general box, press ).
6
Press to return to the date and time display.
7
Each time the machine receives an incoming message, it will call your
programmed transfer number. When you answer, you will hear your
recorded message telling you that the call is a transfer call. On the dial
pad of your phone, enter , your remote code number (see page 62) if
the general box was selected in Step 5, or the box passcode number if a
personal box was selected, and then . Your messages will play.
•
You can also perform any of the remote operations described in Remote
Operations later in this chapter (see page 62).
Note: When you hang up after a transfer call, the machine will not
immediately resume normal operation. If you want the machine to accept calls
immediately after a transfer call, enter twice before hanging up (if
hanging up during message playback, first enter and to stop
playback, then enter twice).
FUNCTION
1
2
0
STOP
0
TRANSFER FUNC
Display:
T.A.D. SETTING
1=YES, 2=NO
The display briefly shows
your selection, then:
ON TAD FAILURE