Bunn FMD-1 - Manual (Page 13)

13
SERVICE
AUGER DRIVE COMPONENTS (CONT.)
5. With the wires removed from the motor . Check
for continuity across the two terminals on the
bottom of the auger motor.
If continuity is present as described, refer to Fig.3 and
reconnect the wires to the terminals on the bottom of
the auger motor, the auger motor is operating prop-
erly.
If continuity is not present as described, replace the
auger motor.
Removal, Cleaning and Replacement
Hopper & Auger
1. Open the dispenser door and raise the top front
cover.
2. Lift the hopper assy (18) over the pins (17) on
hopper support plate (13) and slide hopper as-
sembly out the front of the dispenser.
3. Remove hopper lid (1) and empty product.
4. Lift hopper (2) off of the hopper base(9).
5. Pull off the ejector elbow (16).
6. Remove retainer clip (11) and washer (10) from
the bottom of the hopper base (9).
7. Remove whipper shaft (3), wiper blade (4) and
wiper drive gear (5) from the hopper base (9).
8. Remove auger wire (15) by pulling it out the front
of the hopper base (9).
9. Remove auger drive shaft (14) by removing the
retaining clip (6) from auger drive shaft.
10. Slide spacer (8) and auger drive shaft bracket (7)
off of the auger drive shaft (14).
11. Remove auger drive shaft (14) from hopper base
(9).
12. Wash components in a mild solution of dish deter-
gent using a bristle brush when needed.
13. Rinse and dry each item thoroughly.
14. Check for damaged or broken components, re-
place any if necessary and reassemble hopper
assembly.
15. Install hopper assy (18) in the dispenser by sliding
hopper assy on the hopper support plate (13) until
the slot in the rear of the hopper base (9) seats
against the shoulder screw (12) and pins (17) in
the hopper support plate (13).
FIG. 2 AUGER DRIVE & HOPPER DISASSEMBLY
1. Hopper Lid
2. Hopper
3. Wiper Shaft
4. Wiper Blade
5. Wiper Drive Gear
6. Retainer Clip
7. Auger Drive Bracket
8. Spacer
9. Hopper Base
10. Washer
11. Retainer Clip
12. Shoulder Screw 13. Hopper Support Plate
14. Auger Drive Shaft
15. Auger Wire
16. Ejector Elbow
17. Hopper Locating Pins
18. Hopper Assembly
19. Auger Motor Bracket
20. Auger Motor
21. Dust Seal
22. Auger Motor Mount-
ing panel