Fluid Management H-5 Mixer Digital Timer - Manual (Page 13)

INSTALLATION
H-5 Paint Mixer Operating & Instruction Manual 13
GROUNDING
This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electrical shock by causing the over current
protection device to open the electrical circuit. This product is equipped with
a cord having a grounding wire with an appropriate grounding plug. The
plug must be plugged into an outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
DANGER - Improper installation of the grounding plug can result in a risk
of electric shock. If repair or replacement of the cord or plug is necessary, do
not connect the grounding wire to either flat blade terminal. The wire with
insulation having an outer surface that is green with or without yellow
stripes is the grounding wire.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if in doubt as to whether the
product is properly grounded. Do not modify the plug provided. If it will not
fit the outlet, have the proper outlet installed by a qualified electrician.
This product is for use on a nominal 120-volt circuit and has a grounding
plug that looks like the plug illustrated in Figure 4 on page 14. A temporary
adapter that looks like the adapter illustrated in Figure 5 on page 14 may be
used to connect that plug to a 2-pole receptacle as shown, if a properly
grounded outlet is not available. The temporary adapter should be used only
until a properly grounded outlet can be installed by a qualified electrician.
The green colored ridged ear, lug or the like extending from the adapter
must be connected to a permanent ground such as a properly ground outlet
box cover. Whenever the adapter is used, it must be held in place by a metal
screw.
Improper use of the grounding plug can
result in a risk of electric shock.
DANGER: