Fluid Management H-5 Mixer Digital Timer - Manual (Page 24)

SERVICING AND REPAIR
24 Fluid Management
®
CHANGING OR ADJUSTING POLY-V BELT
Read all of the following instructions. If you have any doubt about
performing these procedures, please contact Customer Service at Fluid
Management. Refer to the Parts Section for component identification and
location.
1. Unplug the power cord from the electrical outlet.
2. Close front cover of the machine.
3. Release the two (2) latches as shown and open rear of machine.
Figure 7 Opening Rear of Machine
4. The belt tension is adjustable with an adjustment bolt and locking nut.
To loosen or tighten the tension, back off the locking nut and adjust with
adjustment bolt as shown.
5. To replace the belt, back off the locking nut and loosen with adjustment
bolt as shown. Remove belt and install replacement as required.
LATCHES
OPEN
OPEN