Fluid Management H-5 Mixer Digital Timer - Manual (Page 26)

SERVICING AND REPAIR
26 Fluid Management
®
CHANGING CONTROL PANEL
Read all of the following instructions. If you have any doubt about
performing these procedures, please contact Customer Service at Fluid
Management.
Turn to the Parts Section for component identification and location.
1. Unplug the power cord from the electrical outlet.
2. Remove the four (4) screws at the top of the control panel and save for
later use.
3. Lift the control panel off of the mixer enough to expose the wiring.
4. Unplug the wire Harness from the rectangular 6-pin connector. This will
free the control panel from the mixer.
5. Remove the control panel and discard.
6. Install the replacement part
7. Re-connect the rectangular 6-pin connector and place the control panel
back on the front of the mixer.
8. Fasten the control panel with the four (4) screws.
The mixer must be unplugged before
attempting this procedure. There is a
chance of electrical shock.
WARNING: ELECTRICAL HAZARD