ARB RD139 - Manual (Page 14)

3 Installing the Air Locker
12
! Lubricate the seal housing running surface on the Air Locker carrier
with oil.
! Carefully install the seal housing by sliding it all of the way onto the
seal housing journal with a gentle twisting motion. This will allow
the O-rings to engage gently (Fig. 6.).
3.4 Installing the Carrier Bearings
!
Apply a thin film of high pressure grease to the bearing journals of
the Air Locker, then press the bearing cones onto the bearing
journals as shown in Figure 7.
Figure 7.