ARB RD100 - Manual (Page 40)

5 Mounting & Connecting the Electrical System
38
5.2.2 Connection to an Alternate Air Source
When connecting the actuation switch to an alternate air source, the
switch(es) should be wired according to figures 29. and 30., depending
on whether one or two Air Lockers will be installed in the vehicle.
5.2.2.1 Single Air Locker System
c If only one Air Locker is to be installed in the system, the switch and
solenoid should be wired according to figure 29. regardless of
whether the Air Locker has been installed in the front or rear axle of
the vehicle.
c Attach the appropriate switch cover (i.e., ‘FRONT’ or ‘REAR’) to
the switch.
NOTE : Refer to Figure 28. for the correct switch terminal
identification and switch orientation.
Figure 29.
SINGLE Air Locker SYSTEM