Switch terminal identification up, 5 mounting & connecting the electrical system, Connection to an alternate air source – ARB RD138 User Manual
Page 33: Single air locker system
5 Mounting & Connecting the Electrical System
31
SWITCH
TERMINAL
IDENTIFICATION
UP
Figure 24.
5
.2.2
Connection to an Alternate Air Source
When connecting the actuation switch to an alternate air source, the
switch(es) should be wired according to figures 25. and 26. depending
on whether one or two Air Lockers will be installed in the vehicle.
5.2.2.1
Single Air Locker System
c If only one Air Locker is to be installed in the system, the switch and
solenoid should be wired according to figure 25. regardless of
whether the Air Locker has been installed in the front or rear axle of
the vehicle.
c Attach the appropriate switch cover (i.e., ‘FRONT’ or ‘REAR’) to the
switch.
NOTE :
Refer to figure 24. for the correct switch terminal
identification and switch orientation.
Figure 25.
SINGLE AIR LOCKER SYSTEM