Fitting procedure – ARB 3410100 User Manual
Page 4
Advertising
FITTING PROCEDURE
1. Place the bull bar on a suitable surface
or stand and fit the indicators using the
hardware provided in the indicator kit.
2. Fit the licence plate bracket to the bull
bar using two M6 x 16mm bolts, M6 flat
washers and M6 flange nuts.
3. Remove the existing bumper bar or bull
bar from the vehicle.
Last Rev Date: 26/05/2006
Page 4 of 9
Fitting instructions# 3783204
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
Advertising