ARB 3410100 User Manual
Page 9
Advertising
19. With the bull bar fitted and all bolt tightened, wire the indicators and winch. (if fitted) Use a
test lamp to find the correct wires for the indicators to tap into and use the scotch locks
provided to join the wires together. Refer to the winch fitting instructions for correct wiring
of the winch. Make sure all wiring is clear of hot, moving or sharp objects.
Last Rev Date: 26/05/2006
Page 9 of 9
Fitting instructions# 3783204
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
Advertising