ARB 3410100 - Manual (Page 7)

FITTING PROCEDURE
11. Fit the licence plate to the bull bar using
two M6 x 16mm bolts, M6 flat washers
and M6 flange nuts.
12. Fit the left and right hand bull bar
mounting brackets to the appropriate
chassis rails.
Note: Due to the age of the vehicles the
use of a hammer may be necessary, if so
use a piece wood against the part. Do not
hit the part directly with the hammer.
13. If necessary use the 25mm spacers
provided in the fitting kit between the
mounting bracket and the out riggers of
the chassis. Fix in place with ½” x 2”
bolts, ½” flat washers, ½” spring
washers and ½” nuts. Do not tighten.
Last Rev Date: 26/05/2006 Page 7 of 9 Fitting instructions# 3783204
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd