ARB 3438320 - Manual (Page 15)

Last Rev Date: 17/11/2009 Page 15 of 18 Fitting instructions# 3787059
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BULL BAR FITMENT TO VEHICLE
60. Fit the pinning bolts to the bull bar in the
drilled positions using 4 x M10 SEMS bolt and
washer sets and M10 flange nuts.
61. Assemble and install combination light
surrounds (p/n 3163015) as per instructions
no. 3786421 supplied with surround kit. Note:
Optional fog lamps can be installed at this
point as per fitting instruction no. 3783315
supplied with fog lamp kit no. 6821201.
62. Wire the combination lamp to the vehicles
indicator and clearance lamp wiring.
Caution: Cable tie all cables together and
keep all cables clear of sharp edges and
moving parts.
Wiring ARB supplied turn signal:
Green wire is Turn signal + (pos)
Red is running lamp + (pos)
Black is – (neg)
63. Attach the stone tray to the under side of
the bull bar with the black M6 bolts, flat
washers & spring washers.
There are four bolts in the front edge
and two in the back edge.
M10 PINNING BOLT