Preparation to vehicle – ARB 3438320 User Manual
Page 6
Last Rev Date: 17/11/2009
Page 6 of 18
Fitting instructions# 3787059
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
15. Remove the template then mask the area to
be cut with 50 mm masking tape to protect
the surrounding surfaces.
16. Cut from wheel arch area first on each side
with the electric jig saw, a second cut may be
necessary to fully cut the support structure
that sits behind the bumper bar.
17. Clean up the cut edges of the bumper bar
with a file or fine sand paper.
18. Starting at the wheel opening end pull the
outer bumper outward slightly and slip the
trim over the cut edge and work the trim
forward.
HINT: You can use a flat blade screwdriver to
prise the bumper away from the reinforcing
structure behind so the trim can be inserted
View in wheel arch
area after cutting
View after cutting