ARB 3938020 - Manual (Page 11)

02/12/04 Page 11 of 12 3782865
ASSEMBLY SEQUENCE FOR WINCH BUMPER.
25. 1. There are two diameter 16 holes located on
the top face of the bar. If no CB aerials are fitted
the holes can be covered with the plastic plugs
provided in the fitting kit.
2. Place the ARB logo on the front face of the
bar in the indentation.
26. (If fitting with winch)
1. Feed the winch cable through the roller fair
lead. Mount the hook to the end of the cable.
27. 1. To replace inner guard trims, reposition on
the vehicle and mark out the edge of the
bullbar wing
2. Using a sharp knife or scissors trim and refit
the guard allowing enough to drill and
position to the bar.
Note: - The trim will sit between the wing brace
and the bullbar wing.