ARB 3938020 - Manual (Page 8)

02/12/04 Page 8 of 12 3782865
ASSEMBLY SEQUENCE FOR WINCH BUMPER.
16. 1. Replace the 2 cap screws, washers and nuts
removed in step 12 above into original holes.
2. Replace the black cover and refit the three cover
screws (DO NOT OVER TIGHTEN)
17. 1. Install the winch and roller fairlead using
bolts, nuts and spring washers supplied by Warn,
and the 4 x 3/8” flat washers supplied in the bolt
kit. Refer to Warn installation instructions for
correct procedure. Adjust winch in slots until the
winch is centralised in the bull bar.
1. Assemble the control box bracket to the
control box using M6 flange nuts.
2. Mount the control box to the bar using M6 X
16 bolts and M6 flange nuts.
NOTE: The gearbox is on the passenger side for
the 8,000lb and 9,000lb. The cable spools from
the bottom for the two winches mentioned.
18. (If not fitting winch)
1. Wrap rubber extrusion around winch cover.
2. Place washers over the winch cover fixing
holes located on the top middle face of the
winch bumper.
3. Place the winch cover on top of the winch
bumper inline with the mount holes.
Bolt together using the M6 button head stainless
steel screws and M6 nuts.