L.B. White FA-MCS - Manual (Page 10)

INITIAL START-UP
■
Connect to a 120 VAC power supply. Set the reset switch
to the ON position. It will take about 30 seconds for the
touch pad to display the following screen.
FIG. 14
INITIAL SET-UP
The following instructions guide you through a step by step
process for setting the various parameters.
If at any time during set-up you want to start over, press the
up/down keys and the center soft key simultaneously to get
back to the Home Screen. Press the right soft key
PARAMETERS, then press right soft key NEXT to scroll to the
area you want to change.
■
Simultaneously press the up/down keys and center soft
key. The following screen is displayed. See Fig.15.
HOME SCREENS
FIG. 15
■
To access Home Screens, press left soft key SET HOME
SCREEN. See Fig.18.
■
There are three home screen displays:
-- Display #1 shows schedule day. See
Fig.16. Then press right soft key NEXT.
FIG. 16
-- Display # 2 shows the actual room temperature for each
zone plus the day in the temperature curve cycle. See
Fig.17.
FIG. 17
■
Press right soft key NEXT.
-- Display # 3 shows Set Point for both heating zones
and schedule day. See Fig.18.
FIG. 18
■
Once you have decided which display you want, press the
left soft key DONE to get back to the Home Screen
selection.
MANUAL MODE OR TEMPERATURE CURVE SELECTION
■
To continue from the Home Screen, press the right soft key
PARAMETERS. The following screen will be displayed.
FIG. 19
■
This is the manual temperature override selection,
allowing you to set and hold a specific temperature.
Once the selection has been made, the SmartBox
™
will hold this temperature.
10
ZONE 1 . ZONE 2
ZONE 1 ZONE 2