L.B. White FA-MCS - Manual (Page 11)

■
Press the center soft key EDIT. The following screen will be
displayed.
FIG. 20
■
Using the up/down keys, select either “‘ENA” to enable the
manual override or “dSA” to disable the override.
ENABLE (Manual Mode)
-- If enable is selected, press the right soft
key NEXT and then up/down keys to set the
temperature that will be maintained by the
SmartBox
™ . See Fig.21.
-- Once the temperature has been selected , press the
left soft key DONE.
-- Zone 1 is now in manual override. After ensuring
the room controller and Smart Box ™ set points are
aligned, no further action is needed.
FIG. 21
DISABLE (Operating on Temperature Curve)
-- Selecting disable deactivates the manual override,
allowing the SmartBox
™
to operate within the
temperature curve.
-- Press the right soft key NEXT. The following screen
will be displayed. Complete the same enabling
or disabling process for Zone 2 as you previously did
for Zone 1.
FIG. 22
-- Press the right soft key NEXT to continue. The screen
shown in Fig.23 will be displayed.
FIG. 26
■
Press the right soft key NEXT to continue set-up. The
screen shown in Fig.24 will be displayed.
SET CLOCK (To run the temperature curve the clock must be
set)
FIG. 24
■
Press the center soft key EDIT to set the clock.
-- Starting with the Month, use the up/down keys to
select Month, day, year, hour, (Note; AM or PM) and
Minutes.
-- Press left soft key DONE to return to SET CLK.
■
Press the right soft key NEXT to continue set-up.
TEMPERATURE SENSORS
■
The following screen is displayed. There are two
temperature sensors for Zone 1 and two temperature
sensors for Zone 2. This screen gives you the option for
either using only one or two sensors for either zone. YOU
MUST USE AT LEAST ONE SENSOR.
FIG. 25
11