L.B. White 125-210K Tradesman - Manual (Page 16)

MAINTENANCE (cont.)
Figure 18 – Spark Plug Replacement
Figure 20 – Photocell Replacement
Figure 19 – Spark Plug Replacement
SPARK PLUG PHOTOCELL
CLEAN AND REGAP EVERY 600 HOURS OF OPERATION OR
REPLACE AS NEEDED.
Ignitor Wire
Screw
Spark Plug
Nozzle Adaptor
Spark Plug
GAP
(For Models CP045DK-CP175EK)
- Remove upper shell (See Air Intake Filter, page 12).
- Remove fan (See Fan Blades, page 13).
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using
medium phillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Reinstall fan and upper shell.
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
- Remove upper shell (See Air Intake Filter, page 12)
- Remove fan (See Fan Blades, page 13)
- Remove photocell from its mounting bracket.
- Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near power switch.
- Disconnect wires from power switch and remove
side cover.
- Disconnect wires from circuit board and remove
photocell.
- Install new photocell and attach wires to circuit board
- Replace switch wires to power switch and side cover.
- Replace fan and upper shell.
(For Model CP210EK only)
- Remove upper shell (See Air Intake Filter, page 12).
- Remove fan (See Fan Blades, page 13).
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using
mediumphillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Reinstall fan and upper shell.
Nozzle Adaptor
Ignitor Wire
Spark Plug
Screw
GA
P
Spark Plug
Switch
Wires
Install Photocell
Incorrect Correct
Side Cover
Bracket
Photocell
Lens
Power
Switch
PhotocellWire
Screw
15