L.B. White 125-210K Tradesman - Manual (Page 9)

TOOLS REQUIRED
CP045DK/CP075DK
- Medium Phillips screwdriver.
on the upper housing.
2. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.
3. Secure handle with screws provided.
4. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap with
the mounting hole on the side covers shown in Figure 4.
5. Secure cord wrap with screws provided.
CP125EK/CP175EK/CP210EK
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
1. Slide threaded axle through the rear section of the wheel support frame.
2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.
3. Attach one cap nut on to each side of the threaded axle and tighten well.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
Installation and Assembly Instructions
ASSEMBLY
WARNING
Fire or explosion hazard!
- Do not operate heater without support frame fully
assembled to tank.
Wheel Support Frame
Wheels
Front-Handle
Rear-Handle
Axle Yes No
No
No
No
No
Yes
Yes
Yes Yes
Yes Yes Yes
Yes
Yes Yes Yes
Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes
Yes No No No
Yes
Cord Wrap
H
Handle
ardware Kit
Model CP045DK/CP075DK CP125EK CP175EK CP210EK
Figure – Component Identification
Handle
Hardware Kit
Cord Wraps
CCPP004455 DK // CCPP007755 DK M Mooddeellss
3.1
Handle
FFiigguurree 44 – Handle and Cord Wrap Installation CP045DK and CP075DK
Front Guard
Screw
Side Cover
Supporter
Cord Wrap
Wedged
Portion
Slit Hole
Screw
CP175 EK CP210 EK
Cap Nut S Cap Nuts L
Flange Screws Nuts
Bushings
Wheels
CP125 EK / /
Cord Wraps
Screws
Front Handle
Rear Handle Axle
Wheel Support Frame
8