BNC 7000 Series User Manual User Manual
User’s manual 2.1, Series 7000 models
Advertising
Table of contents
Document Outline
- Table of Contents
- 1 Introduction to the SERIES 7000
- 2 Getting Started
- 2.1 System Requirements
- 2.2 Unpacking the SERIES 7000
- 2.3 Initial Inspection
- 2.4 Starting the SERIES 7000
- 2.4.1 Applying Power
- 2.4.2 Connecting to LAN via DHCP Router
- 2.4.3 Connecting via LAN without DHCP Router (fallback or fixed IP)
- 2.4.4 Connecting through USB to SERIES 7000 GUI
- 2.4.5 Connecting through USBTMC & VISA
- 2.4.6 Connecting through GPIB & VISA
- 2.4.7 Using Berkeley Nucleonics Application Programming Interface (API)
- 2.4.8 Installing the SERIES 7000 Graphical User Interface Software
- 2.4.9 Troubleshooting the LAN Interconnection
- 2.4.10 Shutting Down the SERIES 7000
- 2.4.11 Perform Firmware Upgrade
- 2.4.12 Serial Number
- 3 Measurement using the Graphical User Interface (GUI)
- 3.1 Start the SERIES 7000 GUI
- 3.2 Organization of the GUI
- 3.3 Measurement Tabs
- 3.4 Phase Noise Measurement Tab
- 3.5 General Measurement Settings
- 3.6 AM Noise Measurement (SERIES 7000)
- 3.7 Additive Phase Noise Measurement
- 3.8 Transient Analyzer Measurement
- 3.9 FFT Analyzer Measurement
- 4 System Calibration (Firmware 1.0 and up)
- 5 Remote Programming the SERIES 7000
- 6 Type and Structure of Commands
- 7 Maintenance and Warranty Information