Behringer UltraDrive Pro DCX2496 - Manual (Page 16)

16 ULTRADRIVE PRO DCX2496 User Manual
4.8.1 INTERNAL/CARD
Fig. 4.46: Store ➠ Internal/Card
In this menu, STORE TO selects the bank to which the preset is stored:
INTERNAL or CARD. The window on the right-hand side lists the presets already
stored in the internal memory or on a PCMCIA card. You can allocate a memory
location to the preset, give it a NAME and overwrite an existing configuration or
select an unused memory location. If you want to overwrite an existing preset,
then confirm your command with OK. The display will prompt you to confirm
once again. Press OK to confirm, or CANCEL to quit.
Fig. 4.47: Store ➠ Internal/Card
If the preset to be overwritten was previously locked in the PRESET LOCK menu
(see chapter 4.8.4), the process cannot be completed; a corresponding message
is displayed.
Fig. 4.48: Store ➠ Internal/Card
If you save to an unused preset location, the store command will be executed
directly, i.e. without further prompts.
◊ Please note that you have to assign a name to each preset.
Presets without a proper name cannot be saved.
AUTO-STORE
Your DCX2496 features an AUTO-STORE function. This means that
all settings are saved automatically, once every few seconds, to a
temporary, non-volatile memory. For example, if there is a power
failure while you’re editing, at least the last few edits (before the
last auto-store operation) are available directly from the auto-store
memory. This function cannot be disabled.
4.8.2 DELETE/FORMAT
Fig. 4.49: Store ➠ Delete/Format
On the next menu page you can erase presets from the internal memory or an
external memory card. Similar to the previous page, just use DELETE to select
the BANK (CARD or INT), then, in the right-hand window, mark the preset to be
deleted. When you press OK, the display prompts you to confirm your selection.
Fig. 4.50: Store ➠ Delete/Format
Press OK to delete the preset. Locked presets cannot be deleted.
Fig. 4.51: Store ➠ Delete/Format
Additionally, this menu page allows you to format a memory card. If CARD
was selected in the DELETE menu, and the FORMAT CARD function is enabled,
the lower display line changes from PUSH OK TO DELETE to PUSH OK TO FORMAT.
Fig. 4.52: Store ➠ Delete/Format
When you confirm with OK, the preset warns you that formatting will erase all
existing presets on the card.
Fig. 4.53: Store ➠ Delete/Format
Confirm formatting with OK. Press CANCEL to quit.
◊ ATTENTION: Formatting will also erase locked presets!
4.8.3 COPY
On the third page of the STORE menu you can copy presets within one bank or
from the internal memory (INT) to a PCMCIA CARD, and vice versa.
Fig. 4.54: Store ➠ Copy
SOURCE selects the memory from which to copy (SOURCE BANK), while
DESTINATION determines the DESTINATION BANK. Below, you can select the
SOURCE PRESET and the DESTINATION PRESET. The display indicates both the
number, name and status (LOCKED/UNLOCKED) of the preset.