Behringer UltraDrive Pro DCX2496 - Manual (Page 27)

27 ULTRADRIVE PRO DCX2496 User Manual
6.10 Stereo 4-way bridged system plus 2 monitors
XENYX X2222USB Mixing console
Stereo master
left channel
Mono out 1
RS-232
In A
6 5 4 3 2 1 Outputs Outputs: 1 2 3 4 5 6
High (4)
LINK
(RS-485)
4-way
loudspeaker tpwers
(In A signal)
High (4)
EUROPOWER EP2000
Stereo power amplifier
High mid (3) High mid (3)
Mid (2) Mid (2)
Low (1) Low (1)
In B signal (5) In B signal (5)
Left Right
In C signal (6) In C signal (6)
Full range
mono monitors
Full range
mono monitors
EUROLIVE F1220A
In B In C In A In B In C
Mono
out 2
(Sub)
Mono out 4
Mono out 3
Stereo master
right channel
Fig. 6.10: 4-way mono-bridged operation plus 2 monitors (per stereo side)
This application uses one ULTRADRIVE PRO for each stereo side. When both units are coupled to each other via the LINK jacks, and one of them is additionally
connected to a notebook/PC, you can use the computer to remotely control both devices with our free CrossOverRemote Software.
In this example, each DCX2496 is supplied with one side of the main stereo signal (In A). Two additional mono signals are routed from the console to inputs B and
C. Two power amps each are used for the 4-way paths of each P.A. stack, while the third power amp drives two full-range stage monitors. This allows for building a
stereo 4-way system that gives the musicians four on-stage monitors that can be “accessed” individually.