Defi ADVANCE Control Unit (DF07701 Manufactured in and before December, 2011) User Manual
Page 10
9. To confirm the wiring and connection, connect gauges and displays to the
control unit temporarily by using meter wires. Do not fix the gauge at this
stage.
Do not remove the convex connector if you use only one METER OUTPUT
connector to protect against short-circuit between two terminals.
10. Connect the negative battery terminal.
11. Confirm that the DC SOURCE LED is on when the ignition is on. If the
power supply wire is wired correctly, the DC SOURCE LED of the control unit
lights in blue. And also look see that CR gauges' illumination lights up/BF
gauges' illumination darkens/ZD's switch illumination lights up when the
illumination switch of the vehicle is on.
●
The DC SOURCE LED is not on: The power supply is not taken.
→ Turn the ignition off, then please confirm the wiring of the power supply wire.
●
The warning LED of gauge is blinking or the warning LED and peak LED are
blinking at the same time: disconnection, short circuit, or communication
error is occurred.
⇒ Refer to 7 -3-2. Error displays of wire disconnection, short circuit, and
serial error.
→ Turn the ignition off, then please confirm the wiring of the sensor and the
sensor wire.
Warning
If the wiring defects are not found, it is probable that there is a defect in the
product. Please detach the product immediately and ask for inspection. It
may damage the vehicle.
⇒ Refer to Maintenance & Check & Servicing.
12. Turn the ignition OFF.
13. Disconnect the meter wire from the gauge, and attach the gauge by using
mounting bracket. Confirm it is installed firmly, then connect the meter wire
again.
⇒ Refer to each gauge operation manual
14. Connect the switch unit to the control unit and fix the switch unit with
double sided tape. Before attaching it , make sure the surface is clean.
⇒ Refer to 5 -3. Part Names & Dimensions of Switch unit in mm(inches).
15. Set 2 dip switches of the control unit.
●
Dip switch 1: Setting the buzzer sound ON/OFF.
●
Dip switch 2: Select the opening/ending mode from A or B when the
ignition is on/off.
⇒ Refer to 5 -2. Part Names of Control Unit in mm(inches), 7 -6-2. Set the
warning buzzer ON/OFF, and 7 -2-1. Change of Opening mode / Ending mode.
16. After setting is done, fix the control unit with attached nuts and bolts and
commercial mounting bracket.
Confirmation
Gauges, including this product, are not waterproof. Please do not install
gauges near the vehicle floor or in wet areas.
54
55