Defi ADVANCE Control Unit (DF07701 Manufactured in and before December, 2011) - Manual (Page 13)

7 -2. Opening mode / Ending mode
When the ignition is turned on, gauges and ZDs performs opening mode.
When the ignition is turned off, gauge and ZDs performs ending mode and
then the power supplies of the control unit, gauges, and ZDs are shut off.
Confirmation
Depending on vehicles, the ignition is not turned off immediately after the
key is turned off. In this case, ending mode doesn't start until the ignition is
turned off.
If the ignition is turned off during setting, the setting data will not be saved.
If the power wire is wired correctly, the DC Source LED lights in blue from
the beginning of opening mode. If it stays off or is blinking, turn the ignition
off and check the wiring.
⇒ Refer to 6 Installation.
7 -2-1. Change of Opening mode / Ending mode
Opening and ending modes can be selected from A type (simple) and B type
(special) by sliding the dip switch 2 on the control unit.
Both types include features of peak&warning LED, the dialing illumination,
lighting/blinking of dial illumination, and sequential indicators of ZD, and so
on besides pointer movement and digital display on ZD. Try both types!
Please slide the switch when the ignition is off. The modes for all the con-
nected gauges and ZDs are changed at the same time.
It might be hard to see the dial illumination depending on outside light
level.
7 -3. Real Mode (slide switch position : U )
After the opening mode finishes, the gauge shifts to Real mode. During Real
mode, the needle pointer displays the actual vehicle condition in real time.
7 -3-1. Warning display
If the gauge reaches or exceeds the value set for warning, the warning LED
goes on. In case of oil pressure and fuel pressure, when the gauge reaches or
falls below the value set for warning, the warning LED goes on. The zone that
the warning item is displayed is highlighted on ZD display. If the buzzer sound
setting is on, the buzzer sounds at the same time as well.
7 -3-2. Error displays of wire disconnection, short circuit, and serial error
If there are disconnection of wire and/or sensor, or short circuits of wire and/
or sensor, the warning LED blinks. Error messages are displayed on ZD display.
Once the error message is displayed, the warning LED keeps blinking until the
ignition is off. Please turn off the ignition immediately and check the wiring of
sensors and wires. If the communication between gauges/ZDs and the control
unit is failed, serial error massage is displayed and warning and Peak LEDs
blink at the same time .
Disconnection(Warning LED blinks)
Peak LED
Warning LED
Serial communication error
(Warning & Peak LED blinks simultaneously)
Short-circuit(Warning LED blinks)
ON
OFF
If an error is displayed, turn the ignition off immediately, and then confirm
the wiring of the sensor and the sensor wire. If any defects are not found,
please ask the shop for inspection.
7 -3-3. Illumination
【ADVANCE CR gauges】
The illumination of CR gauges are turned on/off being interlocked with the
vehicle illumination switch.
By pressing
R button several times during Real mode, Record
mode or Playback mode, the gauge illumination is turned off even if the
60 61