Defi ADVANCE Control Unit (DF07701 Manufactured in and before December, 2011) - Manual (Page 11)

Use mounting brackets with thickness of 3mm(0.1") and under.
Do not use other than the supplied bolts. Use of other bolts may damage
the inside of the control unit.
The control unit contains buzzer. So it may difficult to hear the sounds if the
control unit is installed inside the dashboard or far from driver's seat.
It is possible to change the setting later. In order to change later, please fix
the control unit so as to operate the dip switch.
17. Final confirmation of install completion
Warning
Please be sure to check the following list; otherwise, there is a possibility
that a serious accident may occur.
□ Ensure that all hoses and tubing are permanently attached. Also ensure that
there is no liquid or exhaust leakage.
□ Check that the sensor and wires are not interfering with the engine opera-
tion.
□ Ensure that the gauge and wires are tightly attached, so they don't come
loose and hinder driving.
□ Check that all wires disconnected from the vehicle during installation have
been properly reattached.
Warning
After installation, check that no materials or tools remain in the driver's seat
or the engine compartment. If there are tools left at the feet of the driver's
seat, this may cause a driver to lose control of brake because of tools or
materials caught under the brake pedal. If there are tools in the engine
compartment, the engine may break.
□ Ensure that the negative battery terminal is tightly attached. Close the hood
properly.
This concludes the installation process.
Confirmation
The protection film is attached to ADVANCE Control Unit and the switch
unit. Please peel off before using. It may be sticked by aging of the glue.
56 57