Brother DCP1200 - Manual (Page 70)

5 - 12 P R I N T I N G
Remote Printer Console Main Program
This program allows you to change various printer settings such as
emulation, print quality, fonts, page setup etc., from your computer
screen. Since most DOS applications have a Printer Settings menu that
overrides the settings made by the RPC, you may not have to use this
utility program. This utility program is useful for application software that
does not control the printer’s settings and features.
Printer Status Monitor Program
This utility program can monitor your printer’s status using bi-directional
parallel communications. This utility program stays resident in your
computer memory (Terminate-and-Stay Resident program) and runs in the
background.
Installing the Remote Printer Console
Before you install the program, make sure you have the following
hardware and software to install the program:
DOS Version 3.3 or later
Monitor EGA/VGA or compatible
Option Mouse; the mouse driver must be installed.
(You can also operate the program with the keyboard.)
Follow these steps to install the remote printer console program:
1 Make sure your copier/printer is connected to your computer and it is set
to Online.
2 Start your computer and go to the DOS prompt. If you are in Windows ® ,
exit and return to the DOS prompt.
3 Insert the Brother CD-ROM into your CD-ROM drive.
4 At the DOS prompt (C:\>) type x: (Substitute the drive letter of your
CD-ROM drive for “x”) and press Enter.
C:\>x:
5 Type CD DOS and press Enter.
x:\>CD DOS
6 Type RPCSETUP and press Enter.
x:\DOS>RPCSETUP
7 Follow the instructions from the installer.