GrimmSpeed HiFlow CrossPipe - Manual

G
rimm
s
peed 1
GrimmSpeed HiFlow Crosspipe
Installation Instructions
2002+ Subaru WRX/STi/LGT/FXT
GrimmSpeed HiFlow Crosspipe Installation Instructions
Park your vehicle on a level surface. Fully engage your parking brake and
put wheel stops on the front and rear wheels to keep the vehicle from
rolling.
All GrimmSpeed exhaust components are intended for Off-Road use only.
1.
Remove plastic splash guard (3) 10mm bolts and 4 plastic clips.
2.
Remove passenger side exhaust collector heat shield (4) 12mm
bolts.
3. Remove driver side exhaust collector heat shield (2) 12mm bolts.
4.
Loosen (2) 14mm bolts that connect passenger side exhaust
collector to up pipe.
5.
Remove (2) 14mm bolts that connect passenger side exhaust
collector to crosspipe.
6. Remove (2) 14mm bolts that connect driver side exhaust manifold
collector to crosspipe. Drop crosspipe.