J.P. Instruments EDM 930 Primary Pilots Guide - Manual (Page 61)

For Your Safe Flight Page 56
Section 12 - Appendices
TSO-only differences from Primary Instruments
TSO-only models have the following differences from the Primary
models.

If multiple alarms occur simultaneously, the higher priority
alarm will temporarily “mask” the lower priority alarm(s). When
an alarm occurs, tap the Clear button to clear the alarm
indication so that you will be notified of any other alarm that
might have occurred. The alarm priorities are as follows:
Highest priority CHT High CHT
O-T High OIL temperature
O-P Low oil pressure
F-P Low fuel pressure
TIT High TIT
TK-LOW Fuel tank low
MIN Low fuel endurance remaining
REM Low fuel quantity remaining
F-P High fuel pressure
EGT High EGT
MAP Overboost Manifold pressure
DIF Excessive EGT span
CLD Excessive CHT cooling rate
RPM RPM over redline
O-T Low oil temperature
BUS High battery voltage
BUS Low battery voltage
O-P High oil pressure
AMP Amps discharge
Lowest priority BAL Fuel level out of balance

Aircraft make and model will not be shown in the RAD upon
power up and will not be continuously shown on the bottom of
the display window.

The user can change factory set ranges and alarm limits.
 The Key Card is not programmed with the make, model and year
of your aircraft.
 RAD alarm displays will be cleared and disabled along with the
alarms displayed in the Scanner section.