PHCC Pro Series Pro Series 1000 Battery Backup Sump Pump System (with silence switch) - Manual (Page 3)

Introduction
The PHCC Pro Series 1000 backup sump pump
system is battery-operated. It is designed as an
emergency backup system to support your main
AC sump pump, and it will automatically begin
pumping any time the float switch is activated
by rising water. Should any malfunction or
emergency occur that involves the sump pump,
the battery, or the AC power, the Pro Series
system will sound an alarm. A light on the
display panel of the control unit will indicate the
cause of the alarm and the corrective action.
For added reliability, the float switch has, not one,
but two floats. Should one float fail to operate,
the second float automatically activates the pump.
The Pro Series 1000 Sump Pump System
includes:
• A control unit with a dual float switch, a
battery fluid level sensor, and battery cables
• A pump with a 1½” PVC pipe adapter
• Two (2) plastic wire ties for mounting the
float switch and the control unit
• A battery box
• A battery charger
• A battery cap with a hole to accommodate the
fluid sensor
You will also need to supply:
• A Pro Series 1000 Standby Battery or a Pro
Series 2200 Standby Battery
DO NOT use an automotive battery with this
system
The internal construction of some wet cell
batteries may not be compatible with this
system. Glentronics cannot guarantee the
compatibility of other brands of batteries.
The use of a Pro Series battery is HIGHLY
recommended.
• 1½” rigid PVC pipe and fittings
• PVC cement and primer
• A union with hose clamps or a “Y” connector
and two (2) check valves, depending on the
installation method you use
• A surge protector (recommended)
• Six (6) quarts of 1.265 specific gravity battery
acid
For narrow sump pits
you will need some
additional parts:
• An “L” bracket at
least six (6) inches
long (preferably one
that will not rust)
• Two (2) stainless steel hose clamps
• One (1) stainless steel screw (#8-32 x 3/4”),
a matching washer & nut
Use of a Pro Series
Klunkless Check
Valve™ will provide
quieter operation.
(See back cover for
more information.)
Replacement Part Numbers
Pump . . . . . . . . . . . . . . . . . . . . . . .1011009
Float switch assembly . . . . . . . . . . . .1020009
Fluid sensor assembly . . . . . . . . . . . .1014001
Pipe adapter . . . . . . . . . . . . . . . . . .1120002
Charger . . . . . . . . . . . . . . . . . . . . . .1015003
Battery box . . . . . . . . . . . . . . . . . . .1113003
Call 800-991-0466, option #3 to order parts.
System Specifications
Power supply requirements . . . . . .115 volts AC
Pumping capacity . . . . . . . . . .2000 GPH @ 0’
Pumping capacity . . . . . . . . .1000 GPH @ 10'
Pump dimensions w/elbow . . .6½” H x 8½” W
Pump housing & strainer . . . . . .non-corrosive,
will not rust
Pump . . .can run dry for short periods of time;
can be used in sumps with water softener
Float switch . . . . . . . . . .independent, can be
set at any level
Page 2
Control
Unit
Battery Box
Cap
Wire Ties
Float Switch
Pipe
Adapter
Battery
Wires
Fluid Sensor
Charger
Pump