PHCC Pro Series Pro Series C33 - Manual (Page 3)

Introduction
The Pro Series Pair of Pumps combination system
is designed to provide both primary and backup
pumping capabilities. The primary pump will
operate as long as it is receiving AC power. If
the power is interrupted, or more water is
coming into the sump than the AC pump can
handle, the backup sump pump will begin
pumping automatically. The backup system has
unique monitoring features that diagnose a
problem and sound an alarm. A light on the
display panel of the control unit will indicate the
cause of the alarm and the corrective action.
The two systems have been pre-assembled for
easy installation.
To extend the battery run time, two batteries may
be connected to the Pro Series C33 system by
purchasing a second battery and acid pack, as
well as a set of battery jumper cables. Jumper
cables specifically designed for this use are
available from the manufacturer, Glentronics, Inc.
The Pair of Pumps Combination Sump Pump
System includes:
• A 1/3 HP primary pump with a caged dual
float switch, and a blue piggyback controller
that plugs into the wall outlet
• A gray backup pump
• A gray control unit with a battery fluid
sensor, a dual float switch, battery cables,
and an internal 13 amp charger
• A battery cap with a hole to accommodate
the fluid sensor
• A battery box
• A rubber union
• A battery filler bottle for adding distilled
water to the battery
You will also need to supply:
• A Pro Series B-2200 Standby Battery or a Pro
Series B12-90 Maintenance-Free Battery.
The internal construction of some wet cell
batteries may not be compatible with this
system. Glentronics can not guarantee the
compatibility of other brands of batteries.
The use of a Pro Series battery is HIGHLY
recommended.
• DO NOT use an automotive battery with this
system
• DO NOT use a Pro Series 1000 battery with
this system. It will not run the pump as long
as the Pro Series B-2200 battery
• A surge protector (recommended for the
backup controller)
• Six (6) quarts of 1.265 specific gravity
battery acid
For some installations you may need
additional items:
• 1-1/2” rigid PVC pipe to connect to the
existing plumbing
• A PVC pipe connector or a rubber union
• PVC pipe cleaner and cement
To connect two batteries you will need:
• Two (2) batteries of similar age and capacity
(so they will have equal power)
• Another battery box (optional)
• Two (2) acid packs to fill the dry batteries
• A set of battery cables with rings on both
ends to connect the two batteries together
(available from Glentronics, Inc.)
System Specifications
Power supply requirements.......115 volts, 60 Hz
AC pump pumping capacity......3000 GPH @ 10’
..............................................50 GPM @ 10’
DC pump pumping capacity......2400 GPH @ 10’
..............................................40 GPM @ 10’
Overall dimensions..................11” W x 23¾” H
Page 2
Rubber
Union
Primary Pump Controller
Backup
Pump
Controller
Primary
Pump
Battery Cables
Fluid Sensor
Battery Cap
Backup Pump
Float Switch
Backup
Pump
Battery Box
Battery
Filler
Bottle
Primary
Pump Float
Switch