Important application specific settings, Engine, Cam/crank – AEM Infinity Supported Applications - Toyota 1993-1997 Supra Turbo User Manual
Page 4: Ignition sync, Idle stepper max steps, Infinity tuner wizard setup engine
4
© 2014 AEM Performance Electronics
IMPORTANT APPLICATION SPECIFIC SETTINGS
Infinity Tuner Wizard Setup
Engine
In the Wizard Engine tab confirm the following settings:
Number of Cylinders
= 6
Engine Cycle Type
= 4 Stroke
Ignition Type
= Sequential (Coil On Plug)
Firing Order
= 1-5-3-6-2-4
Cam/Crank
In the Wizard Cam/Crank tab confirm the following setting:
Toyota Supra (1993–1998 Turbo)
Open the Advanced Setup tab and set the following:
Crank Noise Cancellation
= 70
Cam 1 Noise Cancellation
= 70
Add the 1-Axis Lookup Table VR_PwmDuty [%] to your layout. Set the following:
Ignition Sync
Add a text grid control to your layout and select the following channels. Make sure their values match
the settings below for initial timing sync.
TrigOffset [degBTDC]
= 23.00
CamSyncAdjustment
= 11.00
See QuickStart Guide section Setup: Ignition Sync for instructions on timing sync.
Idle Stepper Max Steps
Go to Setup Wizard Idle page and confirm the following setting:
Idle Stepper Max Steps = 33