JB Conversions 2308 Dana 300 - Manual (Page 13)

13
19) With the output shaft supported as shown, slide the larger spacer ring
onto the shaft. The tapered edge on the ring I.D. faces the gear (Fig.21,22).
FIG: 21 FIG: 22
20) Slide the new tapered roller bearing onto the shaft as far as possible by
hand (Fig.23). The shaft is sized to provide a VERY light press fit onto the
shaft. You may be able to slide the bearing up to the spacer ring without the
aid of a punch or press. This fit is intentional to aid in your setup.
FIG: 23