JB Conversions 2308 Dana 300 - Manual (Page 9)

9
12) Note the chamfer on the ID edge of the thrust washer (Fig.13a). Only
one side of the thrust washer is machined with the chamfer. This chamfer
should face the shoulder on the shaft.
FIG: 13a
Place the thrust washer onto the shaft and lower to the shoulder on the
shaft. The tapered edge on the thrust washer I.D. faces the shaft shoulder
(down) (Fig.13b).
FIG: 13b
13) Place the shims supplied in the kit onto the shaft and slide them down to
rest on top of the thrust washer (Fig.14). Procedures for choosing the correct
combination thickness of shims can be done a number of ways depending
upon personal preference. You can start with no shims and work backwards