JB Conversions 2308 Dana 300 - Manual (Page 7)

7
9) Place the case in a press and remove the shaft (Fig.10). The front output
shaft is removed in this photo however it is not necessary for completion of
this kit installation.
FIG: 10
10) From this step forward, an empty, cut-a-way display case is used to
provide better visibility of the components as they are reassembled. Note the
chamfer on the ID edge of the thrust washer (Fig.11a). Only one side of the
thrust washer is machined with the chamfer. This chamfer should face the
shoulder on the shaft.
FIG: 11a
You will notice the lower tapered roller bearing and spacer has been installed
onto the new output shaft (Fig.11b). This has been done to ease your setup