2GIG CDMA CELL RADIO MODULE - Manual (Page 2)

EXISTING INSTALL INSTRUCTIONS
These instructions are written for use when replacing an existing 2GIG‐GC CDMA Cell Radio
Module in a 2GIG Control Panel. The 2GIG‐GC CDMA Cell Radio Module is a snap‐in cell radio that
provides 2‐way‐voice to a Central Station, transmits security information to online portals, and
delivers the latest Over‐The‐Air firmware updates to the 2GIG Control Panel.
IMPORTANT: The Control Panel Firmware must be version 1.9.4 or higher for the CDMA Cell
Radio Module to work.
NOTE: When replacing a 2GIG‐GC CDMA Cell Radio Module, make sure that the new module
is registered with the user’s service provider.
Box Contents
• CDMA Cell Radio Module
• 2 screws
• 2 lock washers
• Install Instructions
As with all electrical appliances, a shock hazard exists if any electrical current is connected to
the 2GIG Control Panel by AC power or battery while inserting, removing or replacing parts.
Removing and replacing Cell Radio Module
1 Disconnect the battery from the 2GIG Panel.
2 Disconnect AC power supply from power source.
3 Open up Control Panel.
4 Detach the antenna (see number 1 in figure).
5 Unscrew the screws (see number 2 in figure).
6 Pull the Cell Radio Module out carefully, without
bending the pins (see number 3 in figure).
7 Plug the new Cell Radio Module into the 2GIG
Control Panel by carefully placing it onto the pins.
8 Secure the module with 2 screws and lock washers.
9 Reattach the antenna.
Removing an internal antenna
1 Disconnect the battery from the 2GIG Control
Panel.
2 Disconnect AC power supply from power source.
3 Lift up side flap on 2GIG Control Panel.
4 Detach the antenna.
5 Pull the internal antenna out from the side of the 2GIG Control Panel.
Removing an external antenna
1 Disconnect the battery from the 2GIG Control Panel.
2 Disconnect AC power supply from power source.
3 Open up 2GIG Control Panel.
4 Detach the antenna.
5 Pull the external antenna from where it was previously installed.
For technical support in the USA and Canada
855‐2GIG‐TECH (855‐244‐4832)
For technical support outside of the USA and Canada
Contact your regional distributor
Visit 2gig.com for a list of distributors in your region
PN: 77:000070‐001 Rev D
CDMA CELL RADIO MODULE