Apple Logic Express 7 - Manual (Page 46)

46 Chapter 6 Filter
Fuzz-Wah
The Fuzz-Wah effect is the standalone plug-in version of the Logic Pro 7 EVD6’s Wah
effect. Its parameters are outlined below.
Parameters of the Fuzz-Wah
FX Order
This parameter allows to you select the order in which the Fuzz/Wah effects are placed.
Choices are: Fuzz –Wah or Wah–Fuzz.
Wah Mode
There are simulations of several classic wah effects, as well as some basic filter types
available. Available models are: off, ResoLP, ResoHP, Peak, CryB, Morl1, Morl2.
Wah Level
Can be used to adjust the level of the wah-filtered signal, relative to the original level.
Also see the Auto Gain section below.
Auto Gain
While sweeping through the main formants of the input signal, the output level of the
Wah may vary wildly, which is not always desirable. Activating the Auto Gain parameter
will automatically compensate for this side-effect. Range: on/off
To hear the difference Auto Gain can make:
• Switch Auto Gain to on.
• Raise the effect level to a value just below the mixer’s clipping limit.
• Make a sweep with a high relative Q setting.
• Now switch Auto Gain to off, and repeat the sweep.