Apple Compressor 3 - Manual (Page 151)

Assigning Files to Surround Sound Channels with Droplets
You can further streamline the channel assignment process by encapsulating the
“automatic” method described above in a Droplet.
For more information about Droplets, see Using Droplets .
Options for Spatial Mixing
This section offers additional insights and suggestions for using the channels in a Dolby
Digital Professional program.
Using the Center Channel
In a multichannel system, there are three ways to achieve a centrally placed sound image.
• Create a “phantom center” (mix sound to the left and right equally, as with
stereo): Commonly used, but assumes the listener is seated exactly between the speakers
(which is not possible in automobiles and not always the case in homes). The timbre
of sound is not the same as from a direct speaker because of cross-cancelation effects.
• Use the center channel alone: This creates a stable center image for listeners in any
location. (To prevent the audio from sounding too focused or narrow, its reverb can
be spread to the left and right channels.)
• Use all three front channels equally or in various proportions: This method allows for
greater control of the range of spatial depth and width. The phantom center can be
reinforced by additional signals in the center channel, which can be enhanced by signal
spread into the left/right pair. The disadvantage is that sound from all three speakers
may not blend well or may not arrive at the listener at the same time, causing side
effects such as comb filtering, shifts in tone color, or smearing. To counteract these
side effects, you can first process the additional signals to change their spatial character,
timbre, or prominence relative to the main center signal.
Using Surround Channels
Subtle surround effects can greatly enhance the listener’s sense of depth compared to
conventional stereo. Popular music often benefits from creative use of surround. But
don’t overdo it. The film industry guideline—don’t use surround effects to distract the
listeners from the story—also works well for music.
Limitations of the LFE Channel
The Low Frequency Effects (LFE) channel is a separate signal with a limited frequency
range and is created by the mixing engineer and delivered alongside the main channels
in the mix. A “brick wall” filter at 120 Hz in the Dolby Digital Professional encoder limits
use of the LFE channel to the bottom two audible octaves. Dolby recommends limiting
the signal to 80 Hz when mixing your sound.
151 Chapter 10 Creating Dolby Digital Professional Output Files