Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System - Manual (Page 25)

a) Cut part of the factory track bar off as shown in the following pictures. The
pictures are shown using a 4 ½” grinder with a cut off wheel, but a sawzall can
also be used.
b) Attach the new track bar relocation bracket to the factory bracket as shown with
the new 9/16” bolt and lock nut; use a flat washer under the bolt head and lock nut.
d) Install the u-bolts over the axle tube and through the track bar relocation bracket,
use a flat washer and nylock nut to secure the u-bolt.
e) Torque the 9/16 bolt to 150 ft-lbs, and the 3/8” u-bolts to 40 ft-lbs
f) Wait until the vehicle is sitting at ride height to attach the track bar.
22. INSTALL LOWER SHOCK RELOCATION BRACKETS AND SWAY BAR
LINKS
a) Cut off the factory lower shock brackets using a grinder with a cut off wheel or a
sawzall. Grind the weld smooth.
Figure 22-1 Figure 22-2